Друзья посмотрите пожалуйста, ломаю голову с инструкцией Китайской сигнализации GSM, всё в основном понятно, только трабл с добавлением и удалением пульта.
Code Pairing of Remote Control
In the status of disarm, enter settings and press [Set] once again, the main unit emits a short "beep" and all the indicators of the defence zone are always on, which indicate that the unit enters remote control code pairing status; take a remote control required for code pairing and press any key on it to emit a wireless signal to main unit; after the main unit receive the signal, it emit a beep and all the indicators of defence zone go out, which indicate the remote control succeeds in code pairing.
Cautions: the main unit can provide code pairing for at most 8 remote controls. Code pairing for all remote controls is the same.
Delete Remote Control
In the status of disarm, enter settings and press [Set] once again, the main unit emits a long
"beep" and all the indicators of the defence zone are always on, and then it enters remote
control code pairing status; press and hold [Set] for 3 seconds, the main unit emits a long
"beep" and all the indicators of the defence zone go out. Remote control paired successfully.
Cautions: when deleting remote control, all the remote controls would be deleted.
